- Waikato Home
- →
- Library Home
- →
- Research Commons
- →
- Browsing by Author
JavaScript is disabled for your browser. Some features of this site may not work without it.
Browsing by Author "Gabbitas, Brian"
Now showing items 1-5 of 24
-
(Trans Tech Publications, 2012)Ti-6Al-4V rocker arms for internal combustion engines were produced by forging of compacts of blended powder consisting of elemental hydride-dehydride (HDH) titanium powder and Al60V40 (wt%) master alloy powder or mechanical ...
-
(ASM International, 2013)Titanium metal injection molding (Ti-MIM) has been practiced since the late 1980s. Logically, the Ti-MIM practice follows the similar processes developed for the antecedent materials such as stainless steel and ceramics. ... -
(Elsevier, 2013)An optimized titanium slurry was developed from 43 vol.% of titanium powder, 0.3 dw.% of dispersant, 0.8 dw.% of plasticizer and 0.8 dw.% of binder, mixed with a balance of distilled water, which produced a viscosity of ...
-
(Trans Tech Publications, 2012)The aim of this study is to investigate the direct manufacturing of a titanium mandible implant via a laser sintering process which involves the different areas of medicine, engineering and product design. The manufacturing ...
-
Effect of milling parameters on microstructure of Ti/Al composite powder produced by discus milling (2006)The motivation of this research is to develop a process for producing Ti/Al composite powders that enable synthesis of a single-phase TiAl intermetallic bulk material, which is then used as a target for physical vapour ...
Now showing items 1-5 of 24
Co-authors for Brian Gabbitas
Supervised by Brian Gabbitas
Showing up to 5 theses - most recently added to Research Commons first.
-
(University of Waikato, 2011)The service life of industrial components is limited predominantly by chemical corrosion, mechanical failure or mechanical wear. In the aluminium high pressure die casting industry, liquid aluminium is extremely reactive ... -
(University of Waikato, 2010)A comprehensive study of cold gas dynamic spray technology is required for optimising performance and gun design for spraying various materials. Cold spraying technology is a new technique in industry and very limited data ... -
(The University of Waikato, 2010)Aluminium and stainless steels are susceptible to pitting corrosion in sea water. Mild steel is susceptible to corrosion in general. Titanium however, has good corrosion resistance in chloride solutions and thus is not ... -
(The University of Waikato, 2010)The purpose of this research is to investigate the microstructure and mechanical properties of Ti6Al4V pre-alloyed powders producing by direct metal laser sintering technique. Through this research, the direct fabrication ...