|dc.description.abstract||This thesis investigates a linear converter technique suitable for microprocessor voltage regulator modules (VRMs). The original linear regulator is the patented supercapacitor assisted low-dropout regulator (SCALDO). A less complex, lower cost design was achieved by reducing the number of switches in the original SCALDO and adding a second low dropout regulator (LDO).
In the initial implementation of this reduced-switch SCALDO (RS-SCALDO), output regulation failed due to the presence of a parasitic body-diode in standard LDOs. The body-diode forms an unwanted discharge path to ground for the supercapacitor. In order to block this path, an application specific LDO that operates in the third quadrant of a MOSFET current-vs-voltage transfer function was investigated.
A 3.5-to-1.5 V RS-SCALDO was designed with a supercapacitor, two LDOs and two switches. Compared with the standard SCALDO approach, this new design halves the number of switches required. Discrete MOSFET-based high-current LDOs were developed and combined with a common feedback control circuit. Voltage identification (VID) capability was implemented using a digital potentiometer. Theoretically, when an LDO converts 3.5 V to 1.5 V a maximum efficiency of 1.5/3.5(~43%) can be achieved. According to the general theory of SCALDO, a single supercapacitor configuration can achieve nearly twice the linear regulator efficiency. The 3.5-to-1.5 V, 5 A RS-SCALDO achieved an approximate end-to-end efficiency of 80%, thus, agreeing with SCALDO general theory.
Large-signal analysis was used to model MOSFET non-linearities and predict the performance of LDOs, switches and the overall system. Matlab modeling predictions for body-diode behaviour were cross-checked via SPICE simulation; the results agreed with bench measurements.
RS-SCALDO regulators cycle at very low frequencies, usually in the range of millihertz to hertz. Therefore, electromagnetic interference emitted by high-frequency switched-mode VRMs is not an issue here. Compared to typical high-frequency VRMs, RS-SCALDO topology provides similar efficiencies with the high slew-rate and low noise output of a linear regulator. In generalized SCALDO configuration with n supercapacitors, a total of 3n+1 switches required; in contrast RS-SCALDO reduces the switch count to 2n. With the elimination of the body-diode parasitics, the technique can be extended to much higher currents.||