Item

Sintering behaviour and microstructures of Ti(Al,O)/Al₂O₃, Ti₃Al(O)/Al₂O₃ and TiAl(O)/Al₂O₃ in situ composites

Abstract
The sintering behaviour and microstructures of Ti(Al,O)/Al₂O₃, Ti₃Al(O)/Al₂O₃ and TiAl(O)/Al₂O₃ in situ composites produced using Al/TiO₂ composite powders have been studied. Ti(Al,O), Ti₃Al(O) and TiAl(O) represent α-Ti phase with dissolved Al and O, and Ti3Al and TiAl phases with dissolved O, respectively. The Al/TiO₂ composite powders were produced by high energy mechanical milling using Al and TiO₂ powders as the starting materials. It was found that the matrices of the composites became fully dense after sintering at 1550 °C, and the Al₂O₃ particles became fully sintered when the sintering temperature was increased to 1650 °C. The reactions between Al and TiO₂ which occur during heating the powder compacts to 1400 °C have little effect on the sintering of the composite powders. The Al₂O₃ particles in the composites become significantly coarsened during sintering at 1550 °C or above, and the coarsening rate of the Al₂O₃ particles increases in the order of Ti(Al,O)/Al₂O₃, Ti₃Al(O)/Al₂O₃ and TiAl/Al₂O₃ composites. This can be attributed to the decrease of the solidus temperature or melting points of the corresponding matrices. It is evident that in the initial stage of sintering, coarsening of the Al2O₃ particles occurs through coalescence. Hipping of the pre-sintered composites at 1300 °C with a pressure of 200 MPa without canning causes significant increase of the density and substantial further coarsening of the Al₂O₃ particles.
Type
Journal Article
Type of thesis
Series
Citation
Cai, Z. H., & Zhang, D. L. (2006). Sintering behaviour and microstructures of Ti(Al,O)/Al₂O₃, Ti₃Al(O)/Al₂O₃ and TiAl(O)/Al₂O₃ in situ composites. Materials Science and Engineering: A, 419(1-2), 310-317.
Date
2006
Publisher
Elsevier
Degree
Supervisors
Rights
Publisher version