Loading...
Thumbnail Image
Publication

Measuring the bulk impedance of brain tissue in vitro

Abstract
Theoretical and numerical models of brain activity suggest a link between seizures and electrical connectivity. We have therefore been motivated to measure electrical conductivity in brain tissue. Such measurements in vitro are difficult; it is necessary to use a conductive inorganic salt solution, artificial cerebrospinal fluid (ACSF), to keep the tissue alive. We have attempted to provide a robust method to make such measurements. Mouse brain tissue was sliced (400 μm) using established methods. Half the slices were placed in standard ACSF; half were placed in ACSF devoid of magnesium ions. The latter case promotes seizure activity. Electrical activity was measured with a tungsten electrode at various places on the slices. Sixty-nine samples of cortex (2 mm × 2 mm) were cut with a razor. Their areas were measured with a calibrated microscope. Each sample was placed between two flat Ag/AgCl electrodes in a Perspex sandwich. Excess ACSF was removed with filter paper. The impedance was measured at 25°C from 20 Hz to 2 MHz with an Agilent E4980A four-point impedance meter in a shielded room, using a low current. Between 1 kHz and 100 kHz the conductivity was approximately 0.2 S m⁻¹; outside this range dispersion occurred. Samples prepared in the magnesium-free ACSF had a conductivity about 10% lower. The Cole-Cole model of conductivity was fitted. There were few significant differences between the parameters for the different groups measured.
Type
Conference Contribution
Type of thesis
Series
Citation
Wilson, M. T., Lin, O. D., Voss, L. J., & Jones, K. (2015). Measuring the bulk impedance of brain tissue in vitro. In Metrology Society of Australasia Conference, MSA Conference, Queenstown, New Zealand, October 14-16, 2015
Date
2015
Publisher
Degree
Supervisors
Rights
© This work is licensed under a Creative Commons Attribution - No Derivatives 4.0 International License.