Bioplastics can be manufactured from protein or carbohydrate sources such as wheat gluten, corn, sun flower, keratin, casein, soy, gelatine and whey. A recently developed bioplastic is Novatein thermoplastic (NTP), which is produced from bloodmeal by adding water, urea, sodium sulphite, sodium dodecyl sulphate and tri-ethylene glycol (TEG), allowing it to be extruded and injection moulded. Bioplastics, compared to their petroleum counterparts, can readily adsorb or lose water, which then changes their physical properties such as tensile strength and glass transition temperature. NTP at different TEG and water contents was exposed to 20-85% relative humidity (RH) environments and change in mass recorded over 35 days to determine equilibrium and dynamic moisture adsorption behavior. Equilibrium behavior was modelled using modified Freundlich and Langmuir- Freundlich isotherms, and dynamic behavior modelled using Pilosof, Singh- ulshrestha, exponential, Langmuir-Freundlich and simple rate equations. Excellent fits were obtained for both isotherms and the last three rate equations gave best overall fits for dynamics. NTP adsorbed up to 28% by weight in water at 85% RH, reaching equilibrium within 20 days. Plastics with high TEG had a greater affinity for water but lower water adsorption rates, while dry plastic samples had a lower adsorption rate than wet samples. The two parameter Freundlich model and the exponential or simple rate model is recommended for modelling NTP equilibrium and dynamic water adsorption.