Show simple item record  

dc.contributor.authorBolzoni, Leandroen_NZ
dc.contributor.authorRuiz-Navas, Elisa Mariaen_NZ
dc.contributor.authorGordo, Elenaen_NZ
dc.date.accessioned2018-06-18T00:39:59Z
dc.date.available2018-05-11en_NZ
dc.date.available2018-06-18T00:39:59Z
dc.date.issued2018en_NZ
dc.identifier.citationBolzoni, L., Ruiz-Navas, E. M., & Gordo, E. (2018). Joint effect of steel addition and press-and-sinter on the properties of low-cost PM Ti Alloys. Key Engineering Materials, 770, 248–254. https://doi.org/10.4028/www.scientific.net/KEM.770.248en
dc.identifier.urihttps://hdl.handle.net/10289/11901
dc.description.abstractCheap alloying elements and creative processing techniques are a way forward to open up more industrial opportunities for Ti in sectors where it is not extensively applied yet, rather than in aerospace and biomedical applications. This study focuses on understanding the joint effect of using a commercial steel powder to add Fe to pure Ti and its processing by press-and-sinter on the behaviour of low-cost PM Ti alloys. It is found that the calibrated addition of steel permits to develop new low-cost Fe-bearing Ti alloys that can satisfactorily be produced using the blending elemental PM approach. Densification of the samples and homogenization of the chemical composition are enhanced by the high diffusivity of Fe. The low-cost α+β alloys reach comparable physical and mechanical properties to those of wrought-equivalent PM Ti alloys, such as Ti-6Al-4V, and are therefore promising candidates for load-bearing lightweight products.en_NZ
dc.format.mimetypeapplication/pdf
dc.language.isoen
dc.publisherTrans Tech Publications
dc.relation.urihttps://www.scientific.net/KEM.770.248
dc.rightsThis is an author’s accepted version of an article published in the journal: Key Engineering Materials. © 2018 Trans Tech Publications, Switzerland.
dc.subjectLow-cost titanium alloysen_NZ
dc.subjectTitanium powder metallurgyen_NZ
dc.subjectPress and sinteren_NZ
dc.subjectBlending elementalen_NZ
dc.subjectHomogeneous microstructureen_NZ
dc.titleJoint effect of steel addition and press-and-sinter on the properties of low-cost PM Ti Alloysen_NZ
dc.typeJournal Article
dc.identifier.doi10.4028/www.scientific.net/KEM.770.248en_NZ
dc.relation.isPartOfKey Engineering Materialsen_NZ
pubs.begin-page248
pubs.elements-id224274
pubs.end-page254
pubs.publication-statusAccepteden_NZ
pubs.volume770en_NZ


Files in this item

This item appears in the following Collection(s)

Show simple item record