Loading...
Thumbnail Image
Item

Development of an integrated sacrificial sensor for damage detection and monitoring in composite materials and adhesively bonded joints

Abstract
Quality assurance of adhesively bonded joints is of vital importance if their benefits are to be exploited across a wide range of industrial applications. A novel lightweight, low-cost, non-invasive embedded sacrificial sensor is proposed, capable of detecting damage within an adhesively bonded joint, which could also be used in a laminated composite structure. The sensor operation uses changes in electrical resistance, increasing as the sensing material area diminishes with damage progression. Initial tests prove the sensor concept by showing that the electrical resistance of the sensor increases proportionally with material removal, mimicking the sensor operation. Thermography is used to verify the current flow through the sensor and that any localised heating caused by the sensor is minimal. Short beam interlaminar shear strength tests show that embedding sensors in a composite laminates did not cause a reduction in material interfacial structural performance. Finally, the in-situ performance of the sensor is demonstrated in quasi-static tensile tests to failure of adhesively bonded Single Lap Joints (SLJs) with sensors embedded in the bond line. Prior to crack initiation an electrical response occurs that correlates with increasing applied load, suggesting scope for secondary uses of the sensor for load monitoring and cycle counting. Crack initiation is accompanied by a rapid increase in electrical resistance, providing an indication of failure ahead of crack propagation and an opportunity for timely repair. As the crack damage propagated, the electrical response of the sensor increased proportionally. The effect of the sensor on the overall structural performance was assessed by comparing the failure load of joints with and without the embedded sensor with no measurable difference in ultimate strength. The research presented in the paper serves as an important first step in developing a simple yet promising new technology for structural health monitoring with numerous potential applications.
Type
Journal Article
Type of thesis
Series
Citation
Ólafsson, G., Tighe, R., Boyd, S., & Dulieu-Barton, J. M. (2021). Development of an integrated sacrificial sensor for damage detection and monitoring in composite materials and adhesively bonded joints. Structural Health Monitoring. https://doi.org/10.1177/1475921721989041
Date
2021
Publisher
SAGE Publications
Degree
Supervisors
Rights
This is an author’s accepted version of an article published in the journal: Structural Health Monitoring. © 2021 the authors.