Show simple item record  

dc.contributor.advisorSammes, Nigel
dc.contributor.advisorBroughan, Kevin A.
dc.contributor.advisorSwan, Janis E.
dc.contributor.authorFenton, Basil
dc.date.accessioned2019-12-01T23:20:59Z
dc.date.available2019-12-01T23:20:59Z
dc.date.issued2004
dc.identifier.citationFenton, B. (2004). Computational and empirical thermal modelling of a proposed SOFC stack housing design (Thesis, Doctor of Philosophy (PhD)). The University of Waikato, Hamilton, New Zealand. Retrieved from https://hdl.handle.net/10289/13218en
dc.identifier.urihttps://hdl.handle.net/10289/13218
dc.description.abstractSolid oxide fuel cells (SOFC) generate electricity cleanly, efficiently and quietly. There has been much effort in commercialising planar and large tubular SOFCs in the past two decades. Some research has involved modelling the mass, thermal and electrical energy flows in SOFC stack designs. Due to increased thermo-mechanical strength, a minitubular configuration offers quicker start up than planar designs, higher power densities than large tubular designs, and the potential for easier sealing. A stack housing design that bundled the small tubular fuel cells inside a three-way heat exchanger was proposed. Effluent fuel from the fuel cells was combusted to form an integrated burner. The air required is supplied by natural convection generated from the exhaust and hot gasses flowing up a flue (chimney). Experimental trials were done with a fabricated test rig (verification cell) to assess the stack housing design when operated with hydrogen-air. Temperature profiles data were collected to investigate the effect of varying fuel flow rate, chimney dimensions, and insulation. Code was written for the finite element program ANSYS® to model the verification cell. This included a simple model for the flame in the verification cell. Robustness of the model was investigated by varying software settings, and comparing predicted temperature profiles with measured temperature profiles for varying fuel flow rates, chimney dimensions, and insulation. The verification cell operated successfully on hydrogen-air but the temperature was not high or uniform enough to support a fuel cell stack. Using insulation increased temperatures and produced a more uniform temperature distribution. Increasing flue length increased temperatures marginally but increasing flue width decreased temperatures by 10%. A simple model for the hydrogen flame was used as the heat source in the verification cell to predict temperature profiles for a given set of flow rates and operating conditions. Temperature profiles could be correlated with flow rate within 10% of actual data for the air and exhaust manifolds, but accuracy was not translated for other fuel flow rates. The benefits and drawbacks of the ANSYS® program for modelling the SOFC stack are discussed and recommendations on further research given.
dc.format.mimetypeapplication/pdf
dc.language.isoen
dc.publisherThe University of Waikato
dc.rightsAll items in Research Commons are provided for private study and research purposes and are protected by copyright with all rights reserved unless otherwise indicated.
dc.titleComputational and empirical thermal modelling of a proposed SOFC stack housing design
dc.typeThesis
thesis.degree.grantorThe University of Waikato
thesis.degree.levelDoctoral
thesis.degree.nameDoctor of Philosophy (PhD)
dc.date.updated2019-10-21T23:45:39Z
pubs.place-of-publicationHamilton, New Zealanden_NZ


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record