Show simple item record  

dc.contributor.authorBell, Jessica Emilyen_NZ
dc.date.accessioned2007-03-16T14:09:47Z
dc.date.available2007-08-03T14:20:42Z
dc.date.issued2007en_NZ
dc.identifier.citationBell, J. E. (2007). Towards a Better Understanding of Coastal Cliff Erosion in Waitemata Group Rock; Auckland, New Zealand. (Thesis, Master of Science (MSc)). The University of Waikato, Hamilton, New Zealand. Retrieved from https://hdl.handle.net/10289/2374en
dc.identifier.urihttps://hdl.handle.net/10289/2374
dc.description.abstractThe soft sedimentary deposits of the Waitemata Group which outcrop on the eastern coastline of the Auckland region are a coastal cliff erosion hazard. The determination of the rate that these cliffs erode for hazard zonation purposes still requires research. A database has been collated of a range of structural, geological, geomorphic and climate parameters from 16 representative cliff sites in order to statistically assess what parameters influence cliff erosion and why erosion rates vary within the relatively uniform geology. Four different lithological units have been defined: sandstone beds of turbidites; sandstone beds of densites (contain rip-up clasts); sand to gravel beds of debrites; and siltstone beds. Cliff rock has very weak to weak intact rock strength; apertures of 0.1 to 15 mm; infill types are soft clay and grit, and hard calcite and iron; spacing of discontinuities are smaller in siltstone beds (≥ 5 mm), and up to 5 m in sandstone and debrite beds; bedding and fault planes are continuous, joints are non-continuous; block size is dictated by bed thickness and non-continuous joints. Shore platform widths were used to determine long-term erosion rates which range from 1.2 to 53.0 mm y-1. Platform morphologies are either sloping or horizontal or are a combination of both. Higher platform benches found at some sites are considered to be the result of a higher period of sea-level or are high-tide benches. Intact and rock mass strength increases northwards. Cliff heights are 8 to 38 m; cliff angles are 51 to 79 . Conditions for sporadic planar and wedge failure were determined at some sites; frittered siltstone and low durability sandstone allow smaller-scale, continual erosion. Castor Bay, Army Bay, Waiwera Beach and Leigh Marine Reserve have the lowest rock mass quality. Musick Point, Narrowneck Beach and Waiake Bay have good rock mass quality. A conceptual model for coastal cliff erosion has been developed for Waitemata Group coastal cliffs, based on the dominant processes that act on the cliffs determined from statistical analysis (student t-test, correlation and regression) and field observations. The primary factor for cliff erosion is bed dip, whereby seaward dipping beds have higher erosion rates than landward dipping beds. The secondary factors for cliff erosion include: the intact and rock mass strength of the rock; the rock mass quality; strength of the siltstone beds; strength and structure of the sandstone beds; and orientation of the bedding planes with respect to the cliff face. Shear stresses are enhanced when beds dip seaward and thus shear failure along continuous surfaces is achievable. When beds dip landward the influence of shear stresses along bedding planes, and their contribution to the removal of individual blocks of rock, is severely inhibited resulting in reduced rates of erosion. There is no relationship between cliff height and erosion rates and cliff heights are mainly controlled by the pre-existing landscape. Cliff angle is controlled by the proportion of sandstone and siltstone (whereby lower cliff angles are more siltstone-dominated), rock mass strength and weathering. Erosion rates do vary in Waitemata Group rock of the Auckland region because of the variation in structural and geomorphic conditions of the cliff, most strongly controlled by the dip angle of bedding planes.en_NZ
dc.format.mimetypeapplication/pdf
dc.format.mimetypeapplication/zip
dc.language.isoen
dc.publisherThe University of Waikatoen_NZ
dc.rightsAll items in Research Commons are provided for private study and research purposes and are protected by copyright with all rights reserved unless otherwise indicated.
dc.subjectWaitemata Groupen_NZ
dc.subjectflyschen_NZ
dc.subjectcliff erosionen_NZ
dc.subjectgeotechnicalen_NZ
dc.titleTowards a Better Understanding of Coastal Cliff Erosion in Waitemata Group Rock; Auckland, New Zealand.en_NZ
dc.typeThesisen_NZ
thesis.degree.disciplineScience and Engineeringen_NZ
thesis.degree.grantorUniversity of Waikatoen_NZ
thesis.degree.levelMasters
thesis.degree.nameMaster of Science (MSc)en_NZ
uow.date.accession2007-03-16T14:09:47Zen_NZ
uow.date.available2007-08-03T14:20:42Zen_NZ
uow.identifier.adthttp://adt.waikato.ac.nz/public/adt-uow20070316.140947en_NZ
uow.date.migrated2009-06-09T23:32:12Zen_NZ
pubs.place-of-publicationHamilton, New Zealanden_NZ


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record